flushing out years of tap water before switching to proper coolant
By Rafaqat Ali • 26 Sept 2026 • in Technical Forums • 21 views
I recently bought a 2016 1000cc Japanese hatchback in Lahore. The engine runs smoothly and the temperature gauge stays steady in traffic, but opening the radiator cap revealed brownish, murky rust water. The previous owner clearly ran straight tap water for years without any corrosion inhibitors.
I bought five litres of genuine pre-mixed coolant to fix this, but a radiator mechanic warned me against putting proper coolant into an old rusted cooling system. He claimed the glycol and detergents will dissolve existing rust scale, which could puncture the heater core or cause the radiator seams to leak.
I am planning to flush the block multiple times with distilled water first until it drains clear, then fill with proper 50/50 coolant. However, I am worried about the water pump seal and the copper heater pipes inside the dashboard.
Has anyone done this switch on a car that ran tap water for years, and did leaks appear right after adding coolant?
